Kirkland · Wolf
Wolf Range Repair, From the Burner Caps Down
Dual-fuel and all-gas Wolf range diagnostics — burners, spark ignition, infrared broilers and the oven cavity underneath.
What people call us about
- Burner clicks forever and never lights, or lights only after a long delay
- Flame burns orange and lazy instead of tight and blue
- Infrared charbroiler glows on one side and stays dark on the other
- The indicator light above a knob comes on, yet the burner or oven stays cold
How the visit runs
- Read us the rating plate On a Wolf range it is on the bottom edge of the control panel at the far right, seen with the oven door open. The model plus what the range is doing usually narrows the fault before anyone sets off.
- Measured at the range Ignition circuit, the gas reaching the burners and, for an oven, the sensor against an independent thermometer. The finding is a reading you can see, not a category.
- A price, then a decision Parts and labour arrive as a single number. Say yes, say no or sleep on it — stopping there costs the $89 service call and nothing more.
- Run up in front of you Burners are lit one by one and the oven is brought to temperature again after the repair, with the same readings taken a second time before we pack up.
What it costs
What range repair runs in Kirkland
A flat $89 pays for the visit and the whole diagnosis; approve the repair and that $89 comes off its price.
Each band is the spread we see for that kind of job on a Wolf range, not a starting price. Two things decide where yours lands: the revision of the part your serial number takes, and how far into the range the work has to go. Either way, the figure is given to you — parts and labour together — before a screw is turned.
- Igniter or spark module
- $180 to $440
- Burner valve or orifice service
- $240 to $580
Replacing it instead
$8,120 to $16,740
That covers a comparable professional range, before installation and ventilation work. Set against it, nearly every job on this list is worth a measured diagnosis before a new range is priced.
From Kirkland kitchens
What people say afterwards
4.9 / 51,679 reviews
Red knob glowed but the whole range was dead. He traced it to a failed thermal cut-out behind the back panel, not the control board two other people had quoted for. Cooking again that afternoon.
Rowan T.
Flames burned orange and sooty after our remodel. He checked pressure at the manifold, found the regulator still set for propane on a natural gas line, corrected it, and every burner is tight blue again.
Milo T.
Two burners had clicked for weeks and the last company wanted a whole new spark module. He lifted the caps, showed me the corrosion underneath, cleaned the ports, and both lit on the first turn.
Marisa H.
Book the diagnostic
Name the burner, the knob and what it does.
Read us the model off the rating plate and describe the flame, the click or the smell. The visit is a $89 service call that comes off the bill if you go ahead, and the repair figure is agreed before a panel is lifted — anywhere in Kirkland.
Visits 8:00 am – 8:00 pm, seven days · calls taken 24/7